ANSI/ESD S20.20:2007 pdf download.Protection of Electrical and Electronic Parts, Assemblies and Equipment (Excluding Electrically Initiated Explosive Devices).
4.0 DEFINONS
The terms used en the body of this document are in accordance with the definitions found in ESO
ADV 1.0. ESD Association’s Glossary of Terms.
5.0 PERSONNEL SAFETY
The procedures and equipment described in this document may expose personnel to hazardous electrical contions. Users of this document are responsible for selecting equipment that compbes with applicable laws, regulatory codes and both external and internal policy. Users are cautioned that this document cannot replace or supersede any requirements for personnel safety.
Ground fault circuit interrupters (GFCI) and other safety protection should be considered wherever personnel might come into contact with electrical sources.
Electrical hazard reduction practices shouki be exercised and proper groundwig instructions for equipment shall be followed.
6.0 ESO CONTROL PROGRAM
6.1 ESD Control Program Requirements
The Program shall include both administrative and technical requirements as described herein. The most sensitive level of the items to be handled, in accordance with the Program, shall be documented. The Organization shall establish, document, implement. maintain and verify the compliance of the Program in accordance with the requirements of this document,
6.2 ESD Control Program Manager or Coordinator
An ESD Control Program Manager or Coordinator shall be assigned by the Organization to verily the compliance of the Program in accordance with the requirements of this document.
6.3 TailorIng
This document, or portions thereof. may not apply to all applications. Tailoring is accomplished by evaluating the applicability of each requirement for the specific application. Upon complehon of the evaluation, requirements may be added, modified or deleted. Tailoring decisions. including rahonale and technical justifications, shall be documented in the ESD Control Program Plan.
7.0 ESD CONTROL PROGRAM ADMINISTRATIVE REQUIREMENTS
7.1 ESD Control Program Plan
The Organization shall prepare an ESD Control Program Plan that addresses each of the requirements of the Program. Those requirements include:
Training
Compliance Verification
Grounding / Equipotential Bonding Systems
Personnel Grounding
EPA Requirements
Packaging Systems
Marking
The ESD Control Program Plan s the principal document for implementing and verifying the Program. The goal is a fully implemented and integrated Program that conforms to internal quality system requirements. The ESO Control Prograni Plan shall apply to all applicable facets of the Organizations work.
7.2 TrainIng Plan
Initial and recurrent ESD awareness and prevention training shall be provided to all personnel who handle or otherwise come into contact with any ESOS items. Initial training shall be provided before personnel handle ESDS items. The type and frequency of ESD training for personnel shall be defined In the Training Plan. The Training Plan shall include a requirement for maintaining employee training records and shall document where the records are stored. Training methods and the use of specific techniques are at the Organizations discretion. The training plan shall include the methods used by the Organization to verify trainee comprehension and training adequacy.
7.3 Compliance Verification Plan
A Compliance Verification Plan shall be established to ensure the Organizations fulfillment of the technical requirements of the ESD Control Program Plan. Process monitoring (measurements) shall be conducted in accordance with a Compliance Verification Plan that identifies the technical requirements to be venfied, the measurement limits and the frequency at which those verifications shall occur. The Compliance Verification Plan shall document the test methods and equipment used for process monitoring and measurements. lithe test methods used by the Organization difler from any 01 the standards referenced in Ihis document, then there must be a tailoring statement that is documented as part of the ESD Control Program Plan. Compliance verification records shall be established and maintained to provide evidence of conformity to the technical requirements
The test equipment selected shall be capable of making the measurements defined in the Compliance Verification Plan.
